1800 SRM 535
Brake Linkage Removal
Legend for Figure 7
1.
CONTROL HEAD
2.
COVER PLATE
3.
BACK COVER
4.
CAPSCREW
5.
LOCKWASHER
6.
NUT
7.
FRONT COVER
8.
KNOB
9.
E-RING
10. ROD WELDMENT
11. SPRING
12. PLATE WELDMENT
13. ROLL PIN
14. BUSHING
15. HANDLE
16. 16. HANDLE
17. PIN
18. CAPSCREW
19. PIVOT
20. LOCKWASHER
21. LOCK NUT
22. CAM
23. PIN
24. SNAP RING
25. STEER HANDLE
26. KNOB
27. NUT
28. PIN W/COTTER PIN
29. YOKE
30. NUT
31. JAM NUT
32. SWITCH PLATE
33. SWITCH
34. BRAKE ROD
35. EYE BOLT
36. ARM AND CAM
37. PIN
38. SNAP RING
39. WIRE HARNESS
40. TOWER
41. NUT
42. LOCKWASHER
43. CAPSCREW
44. PIN
45. SNAP RING
46. BELLCRANK
47. BRAKE ROD
48. COTTER PIN
49. FLAT WASHER
50. DISC
51. CAPSCREW
52. LOCKWASHER
53. ARM CAM WELDMENT
CA60-80XT/XT2, T5XT
See Figure 8.
1.
Raise the drive wheel off the floor. Block the lift
truck see the section Periodic Maintenance
8000 SRM 281. Refer to WARNINGS in Repairs
- General.
2.
Disconnect the battery connector.
3.
Remove the drive unit compartment hood to ac-
cess the brakes.
4.
Discharge the traction motor controller capaci-
tor. Refer to WARNINGS in Repairs - General.
5.
Remove the two capscrews and lockwashers re-
taining covers (14 and 15). Remove the capscrew
(12) and lockwasher (13). Remove knob (10) and
nut (11). Remove covers (14 and 15).
6.
Remove the cotter pins (40) retaining the center-
ing shaft to the yoke arm (38). Remove the cen-
tering shaft. Remove the washers (39). Discon-
nect the cable end from the yoke end (38).
7.
Remove the cotter pin (27) retaining the pin (28)
to the brake arm (20) and rod end (29). Discon-
nect the cable from the rod end.
8.
Remove the pin (21) retaining the brake handles
(19 and 22). Remove the brake arms and han-
dles.
9.
Remove the E-rings (17) from the pin (18). Refer
to WARNINGS in Repairs - General. Remove
the pin (18) from the arm (16). Remove arm.
11
