Troubleshooting
1800 SRM 535
13. Lower the lift truck so the drive wheel is on the
floor. Connect the battery and test the operation
of the lift truck prior to returning the lift truck
to service. The brakes on a C60-80XT and CA60-
80XT lift truck should be capable of holding on
a 10% slope with a maximum rated load. The
T5XT tractor units should be capable of meeting
the 317.8 kg (700 lb) drawbar drag requirement.
All units should also be able to operate without
any brake drag when the hand brake levers are
not applied and the parking brake is OFF.
Troubleshooting
PROBLEM
POSSIBLE CAUSE
PROCEDURE OR ACTION
Brake makes noise.
Brake needs adjusting.
Adjust.
Brake shoes worn.
Replace.
Brake shoes have oil or grease on
them.
Clean or replace shoes.
Brake will not stop unit cor-
rectly.
Brake linkage or shoes not properly
adjusted.
Adjust.
Brake shoes worn.
Replace.
Brake spring broken.
Replace.
Brake shoes have oil or grease on
them.
Clean or replace shoes.
Brake switch not working properly.
Adjust or replace.
Brake will not release.
Brake not properly adjusted.
Adjust.
Brake linkage worn.
Replace.
Brake spring broken.
Replace
(C60-80XT,
CA60-80XT,
T5XT).
Brake switch not working properly.
Adjust or replace.
18
