Figure 15. Axle Shaft Tightening Sequence,
S30-35FT, S40FTS (F010), H1.6-1.8FT, H2.0FTS
(H30-35FT, H40FTS) (G001), S2.0-3.5FT (S40-70FT,
S55FTS (H187), and S50CT (B267)
Figure 16. Axle Shaft Tightening Sequence,
H2.0-3.5FT (H40-70FT) (P177) and H2.0-2.5CT
(H50CT) (B274)
ADJUST
1.
Remove air from brake hydraulic system. See
2.
Install wheel on hub. Tighten wheel nuts to tor-
que specified below for your lift truck.
a.
Tighten between 340 to 380 N•m (251 to
280 lbf ft) for lift truck models
• S2.0-3.5FT (S40-70FT, S55FTS (H187)
b.
Tighten between 450 to 500 N•m (332 to
369 lbf ft) for lift truck models
• H2.0-3.5FT (H40-70FT) (P177)
c.
Tighten between 155 to 175 N•m (115 to
130 lbf ft) for lift truck models
• S30-35FT, S40FTS (F010)
• H1.6-1.8FT, H2.0FTS (H30-35FT,
H40FTS) (G001)
• S50CT (B267)
• H2.0-2.5CT (H50CT) (B274)
3.
Start engine and tilt mast backward to remove
blocks. Push on brake pedal. Pedal must not
touch floor plate. Move lift truck in REVERSE
and push on brake pedal to permit adjusting
mechanism to operate. Repeat this operation
several times.
4.
Service brakes must be adjusted before parking
brake can be adjusted. See Figure 18 and fol-
lowing paragraphs in this section for correct ad-
justment of parking brake.
INCHING OVERLAP ADJUSTMENT
NOTE:
Perform following procedure for lift truck
models
• S50CT (B267)
• H2.0-2.5CT (H50CT) (B274)
NOTE:
The amount of overlap is adjustable
through a ten-point range with 1 being minimum,
10 the maximum, and 5 the default.
1.
Set inching overlap to default using the follow-
ing procedure.
a.
Start engine and check inching overlap indi-
cator on display. Perform Step b or Step c to
adjust overlap.
b.
To increase overlap, press Scroll Up button
on display switch cluster. See Figure 17.
c.
To decrease overlap, press Scroll Down but-
ton on display switch cluster. See Figure 17.
Service Brakes Repair (Dry Brake)
1800 SRM 1743
18
