Loading and Safety Operation
4
─
43
─
5. Hold the load by putting it against the
backrest and then lift the fork 15 to
20cm from the ground. Then, tilt the
mast back as much as possible.
De-stacking
De-stack the load with the following procedure.
1. Slowly approach the load to be transported.
2. Bring the lift truck to a complete stop
in front of the load.
3. Tilt the mast to the vertical position,
and position the lift truck squarely
with the load. Lift the fork to the
position where the forks are inserted.
Slowly advance, and insert the forks
in completely.
● Never travel, turn or tilt the forks while the load is raised, as the load
will be unstable and the lift truck could tilt over.
● If the load blocks the forward vision range, travel backwards.
CAUTION
Keep the forks parallel with the pallet,
and insert them completely while
taking care not to brush against the
pallet.
CAUTION
● Never place a weight on the rear of
the lift truck to increase the loading
capacity. (Refer to the Loading
Capacity Table.)
WARNING