How to Drive
5
─
65
─
Stopping and Parking
1. When stopping the lift truck, release the foot from the accelerator pedal or
Monotrol pedal and push on the brake pedal to slow down.
2. When parking, let down the fork on the floor surface and tilt the mast forward.
Then, put on the parking brake and put the shift lever into neutral.
3. When leaving the fork lift truck, confirm engine speed is low idle speed.
( Do not step accelerator pedal, and do not increase engine speed. )
Then, turn the key switch “OFF”, and always remove the key.
4. If the key switch stays “ON” for 3 minutes after the engine turned off, warning
alarm sounds.
After Operation
After operating, always carry out the post-operation inspection.
● Always park at the designated place.
● Do not park on a slope.
If parking on a slope is unavoidable, securely chock the tires.
● Select a safe place where traffic will not be obstructed when parking,
and install cautionary signs, signal lights or fences, etc., as required.
● Select a sufficiently hard surface for parking, and make sure that the
tires will not slip or sink into the ground.
● Always lower the forks to the ground. If the forks cannot be lowered due
to a fault, etc., wrap the ends with cloth, etc., and park in a place and
direction where persons or lift trucks will not pass.
● Leave the lift truck after it has completely stopped. Always leave the lift
truck while facing its direction.
● Never jump off the lift truck as it is dangerous.
CAUTION
