NOTE:
THE LUBRICATION FITTING NEEDS TO BE
ORIENTED 45° TO CENTERLINE AND REAR OF
LIFT TRUCK.
1. SNAP RING
2. PIN
3. SEAL
4. TIE ROD
5. SEAL
6. BEARING CONE (LOWER)
7. O-RING
8. BEARING CUP (LOWER)
9. SEAL
10. SHIM
11. BEARING CAP
12. CAPSCREW
13. LUBE FITTING
14. OIL SEAL
15. WEAR SLEEVE
16. BEARING CONE (INNER)
17. BEARING CUP (INNER)
18. BEARING CONE (OUTER)
19. BEARING CUP (OUTER)
20. HUB
21. COTTER PIN
22. WASHER
23. CASTLE NUT
24. HUB CAP
25. SEAL
26. WEAR SLEEVE
27. BEARING CUP (UPPER)
28. BEARING CONE (UPPER)
29. PLUG
Figure 8. Spindle Assembly
Install
1.
Install tie rod end to spindle arm and steering
cylinder with pins, seals and snap rings. See
Figure 6.
2.
Install plug on the top of the spindle.
3.
Install the bearings and wheel. See Steering
Axle Assembly Repair for procedures.
4.
If necessary, repeat the procedure for the other
spindle and tie rod.
5.
Remove lift truck from blocks.
TIE RODS
Remove
WARNING
PUTTING THE LIFT TRUCK ON BLOCKS
The lift truck must be put on blocks for some
types of maintenance and repair. The removal of
the mast, drive axle, battery, or counterweight as-
semblies will cause large changes in the center of
gravity. When the lift truck is put on blocks, put
additional blocks in the following positions:
•
If the mast and drive axle are removed, put
blocks under the counterweight so the lift
truck cannot fall backward.
•
If the counterweight is removed, put blocks
under the mast so that the lift truck cannot
fall forward.
Put the lift truck on blocks on a solid, even, and
level surface. Verify the blocks or stands have
enough capacity to hold the lift truck. Use addi-
tional blocks next to the tires as necessary to pre-
vent movement of the lift truck. Verify the lifting
devices used during repairs can lift the weight of
the parts and assemblies.
See the Operating Manual or Periodic Mainte-
nance manual listed in the General of this manual,
for the procedures to put the lift truck on blocks.
1.
Put the lift truck on blocks.
Spindles, Bearings, and Tie Rods Repair
1600 SRM 1952
10
