Default Flow Settings Screen
Figure 13. Default Flow Settings Screen
NOTE:
The arrow icon that displays in the upper
left of the screen acts as a back button, indicating
the active screen is a subscreen.
The Default Flow Settings screen contains three
drop-down list boxes and a set button for easy set-
ting of the valve and flow settings. See Figure 13.
The screen is accessible via the Truck Configura-
tion screen by clicking on the Set Default Flow
Values button. See Figure 7.
Using the serial number of the truck, the hydraulic
controller automatically selects the pump settings.
Check this selection against actual installed parts
and press the F4 key to save the pump setting to
the controller. Changing pump settings can only be
done at the service/engineering level.
Next, mast and carriage settings can be selected
from their corresponding drop-down list boxes, and
saved to the controller by pressing the F4 key.
To load the default flow and valve settings for the
pump, mast, and carriage, click on the Set Default
Flow Settings button that appears below the
drop-down list boxes.
General Functions of the Interface
2200 SRM 1481
18
