Tilt Cylinder Repair
2100 SRM 103
Tilt Cylinders Using Chevron Packing
NOTE: Always use new seals and O-rings. Make
sure all parts are clean. Lubricate all parts with
clean hydraulic oil.
NOTE: The following procedure is for the H360-650C
(early model). See Figure 5.
NOTE: After assembly is complete, install the rod
end on the cylinder rod. Tighten the capscrew on the
rod end as specified in Mast section for your specific
lift truck.
1.
CYLINDER SHELL
2.
NUT
3.
PISTON HEAD
4.
O-RING
5.
NYLON RING
6.
PACKING
7.
NYLON RING
8.
PISTON HALF (FLAT)
9.
PISTON ROD
10. O-RING
11. BACKUP RING
12. RETAINER
13. O-RING
14. BACKUP RING
15. BUSHING
16. PACKING
17. RETAINER RING
18. SETSCREW
19. WIPER RING
Figure 5. Tilt Cylinders With Chevron Packing (Early Model H360-650C)
6
Summary of Contents for H3.50-5.50XM
Page 4: ...THE QUALITY KEEPERS HYSTER APPROVED PARTS...
Page 19: ......
