2100 SRM 103
Tilt Cylinder Repair
1.
CYLINDER SHELL
2.
SNAP RING
3.
LOCK NUT
4.
DOWEL
5.
PISTON RING
6.
O-RING
7.
SEAL RING
8.
PISTON RING
9.
PISTON
10. THRUST PLATE
11. O-RING
12. BACKUP RING
13. PISTON ROD
14. O-RING
15. BACKUP RING
16. RETAINER
17. SEAL RING
18. WIPER RING
19. RETAINER RING
20. PLUG
21. CAPSCREW
Figure 4. Tilt Cylinders for H700-800A, Early Model H700-920B
INSTALL
1.
Use a lifting device to move large tilt cylinders.
Put the cylinder in the lift truck. Install the an-
chor pin in the frame. Install the retainer pin or
cotter pin.
2.
Install the anchor pin at the mast mount. Install
the retainer pin or cotter pin for the anchor pin.
Tighten the capscrews for the retainer pins.
3.
Connect the hydraulic lines to the tilt cylinder.
4.
Operate the tilt cylinders. Check for correct op-
eration and leakage. Adjust the tilt cylinders
as described in Tilt Cylinder Leak Check and
Tilt Cylinder Stroke and Mast Tilt Angle Adjust-
ment.
5
Summary of Contents for H3.50-5.50XM
Page 4: ...THE QUALITY KEEPERS HYSTER APPROVED PARTS...
Page 19: ......
