Set Load Weight to Zero
The operator can set the load weight to zero, when the no
load weight displayed on the LCD screen with the forks/
attachment 0.6 m (2 ft) off the ground and is not within ±2%
of truck capacity. Example: This is ±45 kg (100 lb) for a
2268 kg (5000 lb) truck.
To set the Load Weight System to zero, perform the follow-
ing procedures:
1.
Turn lift truck power
ON
.
2.
If lift truck is equipped with optional Operator Password
feature, enter operator password to enter the main menu.
See the section
for procedures.
3.
If lift truck is equipped with optional Operator Checklist
feature, fill out the checklist questions. See the section
for the procedures. After checklist is
completed, the LCD screen will show the
Operator Screen
.
4.
From the
Operator Screen
, press the scroll back (left
arrow key) or scroll forward (right arrow key) to go to the
Calibrations Menu Screen
. See
.
5.
Press the enter (3) button to select the
Calibrations
Menu
.
6.
Press the #2 button to scroll up or the #3 button to scroll
down until the Weight Icon appears on the LCD screen.
See
7.
Press the enter button (*) to select the Load Weight-Set
Zero feature.
8.
With no load on the forks, position the mast in a vertical
position. See
9.
Lift the empty forks/attachment 0.6 m (2 ft) off the ground
but if free-lift cylinder is present, not more than maximum
free lift. Then, lower the forks/attachment 51 mm (2 in.),
wait 1 second, and IMMEDIATELY press the (*) key to set
the zero point.
The Load Weight System is now set to zero.
Operating Procedures
103
Property of American Airlines