S706/5
COMPLETION OF INSTALLATION
9. Refit lid to RWD box ensuring that ribbon cable is reconnected to the
main PCB and the lid seal is in place.
10. Switch on power. The green "POWER" LED should illuminate.
OPERATION
POWER STATUS
The Power LED will remain illuminated to indicate that there is mains
power to the unit
ALARM CONDITION
When an alarm condition occurs the corresponding channel LED on the
RWD lid is illuminated and the sounder/beacon will activate.
RWD SWITCH CHANNEL FAULT INDICATION
If any of the channel LEDs flashes repeatedly then this indicates a fault
with the RWD switch channel.
RWD ALARM MUTE
Pressing the mute button for 1.5 seconds will silence the sounder and stop
the beacon flashing when an alarm condition is occurring.
If the mute button is not depressed the sounder will silence after 20
minutes leaving the beacon and channel LED on.
The channel LED will remain on until the alarm condition has been rectified
(remote switch returns to its normal position).
ALARM TEST
To test the RWD, push and hold the test button on the lid. If the RWD is
functioning correctly the sounder should activate, the beacon will flash (if
fitted) and all activated channel LEDs will illuminate.
If any of the channel LEDs flashes repeatedly then this indicates a fault
with the channel.
