Installation
User Manual
32
bottom to top, top to bottom, and bottom to top again. Cut off the tape after the three-layer is done.
Tighten the tape at each layer to ensure waterproof.
c. Wrap three-layer PVC insulation tape over the waterproof tape. Starting from 30 mm from the
bottom of the waterproof tape, wrap the three-layer PVC insulation tape in the same method as
introduced in step b.
d. Bundle cable ties at 3–5 mm from both ends of the tape.
5. Check the dustproof cap of the antenna connector, and waterproof it in the same method as introduced
in step 4.
6. Waterproof idle connectors on the bottom of DS-9300 device without removing the protective caps,
according to step 4.
7. Lay out the cable according to design requirements and fix the cable with cable ties.
8. Attach labels or tags to the installed cable.
Installing the Power Cable
Note
Power cable delivered with DS-9300 device is 3*18 AWG cable.
1. Connect one end of the power cable to the PWR connector of DS-9300 device and the other end to the
external power supply. Lay out the cable according to design requirements and fix the cable with cable
ties.
3. Attach labels or tags to the installed cable.
Installing the Monitoring Cable
1. Remove protective cap from the EXM/LCT connector of DS-9300 device. Connect one end of the
monitoring cable to the EXM/LCT connector of DS-9300 device and the other end to the external
monitoring device.
3. Lay out the cable according to design requirements and fix the cable with cable ties.
4. Attach labels or tags to the installed cable.
Installing the Optical Fiber
The remote unit receives signals from the donor unit at CPRI 0 and outputs signals to the connected
remote unit at CPRI 1, as shown in the following figure.
Summary of Contents for DS-9300
Page 1: ...User Manual...