User Manual
Installation
33
Procedure of installing the optical fiber is described as follows:
1. Connect the optical module to the SFP connector of DS-9300 device, as shown in the following figure.
Note
DS-9300 device adopts a dual-fiber single mode optical module with a transfer rate of 1.25 Gbps, a
wavelength of 1,310 nm and a communication distance of 20 km.
a. Rotate the bail clasp latch down.
b. Insert the optical module into the SFP connector.
c. Rotate the bail clasp latch back.
2. Connect the fiber pigtail to the optical module and the other end of the fiber to the external transmission
device, as shown in the figure below.
1
2
3
Summary of Contents for DS-9300
Page 1: ...User Manual...