1) Hold the running machine over the grass and knock the ground several times with the cutting
head the nylon line will get prolonged in thus way.
2) The cutter enclosed in the protection shield will cut the nylon line to the required length.
Caution! The nylon line remnant may be thrown off and cause an injury.
If the machine is vibrating:
Clean it or, where necessary, and remove the grass stuck on the cutting head and protection shield.
MAINTENANCE
THE IMPORTANCE OF MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free operation. It will also help
reduce pollution.
WARNING
！
Improper maintenance, or failure to correct a problem before operation, can cause a
malfunction in which you can be seriously hurt or killed.
Always follow the inspection and maintenance recommendations and schedules in this
owner’s manual.
To help you properly care for your equipment, the following pages include a maintenance schedule,
routine inspection procedures, and simple maintenance procedures using basic hand tools. Other
service tasks that are more difficult, or require special tools, are best handled by professionals and
are normally performed by our dealer or other qualified mechanic.
Make sure that the engine has stopped and the sparkplug wire is disconnected, and is
cool before performing any service to the machine. Contact with moving cutting head or
hot muffler may result in a personal injury.
Read the instructions before you begin, and make sure you have the tools and skills
required.
To reduce the possibility of fire or explosion, be careful when working around gasoline.
Use only a nonflammable solvent, not gasoline, to clean parts. Keep cigarettes, sparks
and flames away from all fuel related parts.
If the maintenance and checking of the equipment are carried out regularly, the service life of
your tool will be greatly increased, and its use more efficient. The tool must always remain in
good working condition, including cutting elements, accessories and guards.
Check the fasteners for looseness, fuel leaks and damaged parts (eg cracks in the saw blade).
The use of non-compliant accessories and parts, improper maintenance, improper assembly
/ disassembly of the machine and accessories can damage the machine, give poor cutting
results and cause bounces and accidents.
Do not modify the machine or remove parts that can not be removed by the operator. Only a
qualified service can do these tasks.
Summary of Contents for HCOMBI336F-A
Page 39: ......
