Be sure to round off the front edge to reduce the chance of kickback
Make sure every cutter has the same length and edge angles as illustrated.
TRANSMISSION
The reduction gears are lubricated by multipurpose, lithium-based grease in the transmission.
Supply new grease every 25 hours of use or more often depending on the job condition.
When adding lubricant, use a grease gun to insert lubricant into the three grease nipples located on the
transmission.
STORAGE
Aged fuel is one of major causes of engine starting failure. Before storing the unit, empty the fuel tank and run
the engine until it uses all the fuel left in the fuel line and the carburetor.
If the fuel tank is drained, this should be done outdoors.
Cleaning and maintenance the machine before storage.
Store the unit indoor without direct sunlight and taking necessary measures for rust prevention.
Store the unit in a locked place out reach of children.
Store the unit where the fuel vapour will not reach an open flame or spark. Always allow the machine to cool
down before storing.
When storing the machine, always fit the cutting device transport guard.
DISPOSAL
When disposing your machine, fuel or oil for the machine, be sure to follow your local regulations.
Grease fitting
Cutter length
Filing angle
Side plate angle
Top plate cutting angle
Summary of Contents for HCOMBI336F-A
Page 39: ......