(4) Thick work gloves
(5) Non-slip-sole work boots
Do not wear loose clothing, jewelry, short trousers, sandals, or go barefoot. Do not wear
anything which might be caught by a moving part of the unit. Secure hair so it is above shoulder
length.
WORK PLACE
Never start the engine inside a closed room or building. Exhaust gases contain dangerous
carbon monoxide.
Never use the product:
a. When the ground is slippery or when you can’t maintain a steady posture.
b. At night, at times of heavy fog, or at any other times when your field of vision might be limited
and it would be difficult to gain a clear view of the working area.
c. During rain storms, during lightning storms, at times of strong or gale-force winds, or at any
other times when weather conditions might make it unsafe to use the product.
The machine may not be used unless it is undamaged and functions properly. If the equipment
or parts of it have become defective, have it repaired by a specialized technician.
Always obey the current national and international safety, health, and working regulations.
Do not operate the machine unless you did not find any faults on checking. If a part has become
defective, make sure to replace it before you use the machine again.
The environment must be free of easily flammable and explosive materials.
Do not overload the machine. Use the machine only for its intended purpose.
Always work with care, and stay alert: Do not operate the machine when you are tired, ill, or
under the influence of alcohol, drugs or medication, as you will no longer be able to operate the
machine safely.
BEFOR STARTING THE ENGINE
Make sure that no persons or animals are within your work area when you start working.
Make sure there are no obstacles in your work area.
Ensure that your machine has been fully and properly assembled.
Check that the machine works properly and make sure, in particular, that the On/Off switch
works properly. Do not operate the machine with a damaged or extensively worn cutting device.
The machine will vibrate during operation. This may cause its screws and parts to loosen.
Therefore, check all screws and parts for tightness.
USING THE PRODUCT
IMPORTANT!
Cut only materials recommended by the manufacturer. And use only for tasks explained in the
manual.
Keep bystanders and animals at least 15 m away from the operating point. If you are
approached, immediately stop the engine.
Grip the handles firmly with both hands using your whole hand.
Assume a firm standing position during operation:
Make sure you cannot slip or fall over.
Do not stretch your arms too far in front of you or above your shoulder level.
Summary of Contents for HCOMBI336F-A
Page 39: ......
