A
C
B
21
Starting Procedure
STEP 2
2Prime the fuel pump (B) by pressing primer
bulb several times until you can see fuel in the
bulb and pipes.
STEP 3
Put the stop switch (A) into the start position.
STEP 4
4Lightly pull on the starter cord (C) until you
can feel resistance, then pull on the cord
quickly and firmly until the engine starts.
CAUTION -
Do not pull out the starter cord
more than approx. 50cm, and let it recoil slowly
by hand. For efficient starting, it is important to
pull the starter cable quickly and powerfully.
!
STEP 5
After running for 10 seconds or so, squeeze
the throttle trigger to release the choke lever
(A) to the RUN position.
WARNING -
The earth auger only begins to
rotate when the throttle lever is used.
!
Summary of Contents for HYEA5200X
Page 1: ...EARTH AUGER HYEA5200X Instruction Manual ...
Page 36: ...36 Notes ...
Page 37: ...37 Notes ...