www.hyundaipowerproducts.co.uk
01646 687 880
aftersales@hyundaipowerproducts.co.uk
CAUTION -
DO NOT
use a hose pipe or pressure washer to clean the engine. Water can
damage the engine or contaminate the fuel system.
NOTE
Engine must be switched off and spark plug lead disconnected.
!
!
After Each Use
• You must remove grass and mud from the machine to prevent it from drying. This will cause
problems the next time the machine is used.
• Wipe the machine down with a damp cloth.
• For larger build ups of debris, use a scraper or similar product.
• Dry the machine completely to prevent rust from forming.
• Make sure not to drip petrol onto the plastic parts to prevent damaging them and remove all
traces of spilt petrol immediately. The warranty will not cover damage to plastic parts caused by
petrol.
Regularly
• Paint on internal chassis parts may start to flake over time due to abrasive action of cut grass.
If this happens, you should touch-up with rust-proof paint to prevent rusting that could corrode
the metal. You can use a light spray oil such as WD40 on exposed parts and cutting deck to help
prevent rust.
• Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use.
Cleaning
Maintenance
43
Hose Attachment
• Connect a garden hose to the quick release
hose connector on left side of the cutting deck,
lower the cutting deck, start the engine and
turn on water supply. Run engine for 2 minutes
to clean underside of cutting deck.
