5-33
Install the dust wiper to the gland using a special
installing tool. Coat the dust wiper with grease
slightly before installing.
Set a special tool the cylinder, gland assembly
into the cylinder tube.
(3)
(4)
Using a hook spanner, install the gland
assembly, and tighten it with torque 40
Ü
4kgf
Â
m
(289
Ü
29lbf
Â
ft).
(5)
D353SE29
D353SE30
After the gland assembly was installed to the
cylinder tube, calk at the tube end into the groove
on the gland to prevent screw loosening.
If it need calking again, never using previous
calking position.
(6)
ö
D353SE31
Move the piston rod back and forth several times for the full distance of its stroke. This helps to
seat the ring and seals before applying full hydraulic pressure to the cylinder.
Install cylinder into trail axle.
While idling the engine with the rear wheels off the ground, operate the steering wheel left and
right alternately.
Then, repeat the above operation at gradually increasing engine rpm. This releases air
from the system and completes preparation for operation.
Stop the engine, lower the floating rear wheels, and check pump joints for oil leaks and looseness
and retighten, them as required.
(7)
(8)
(9)
ö
(10)
