18
Start-up
1.
Make sure the regulator knob is turned fully counter-clockwise.
2.
Plug the power cord into a properly grounded power outlet.
3.
Turn the ON/OFF switch to the ON position.
4.
Allow the compressor to reach the cut-out pressure. The
compressor will shut off automatically.
5.
Attach a hose and the desired accessory to the unit.
6.
Adjust the regulator knob to the desired pressure.
Shutdown
1.
Make sure that the ON/OFF switch is in the OFF position.
2.
Unplug the power cord from the outlet.
3.
Turn regulator knob counter-clockwise until the regulated
pressure gauge reads 0 PSI.
4.
Remove the attached hose and accessory.
5.
Drain all air and water from the air tank.
6.
Once the tank is fully drained, close the drain valve.
7.
Store in a safe, dry, non-freezing area.
Storage
1.
Do not store the compressor in areas that are humid and/or
subject to temperature fluctuations. This may result in excess
moisture or water forming in the tank, which may affect the
compressors cycle times.
2.
Do not store in areas with excessive dust.
3.
After the ON/OFF switch is in the OFF position, unplug and
properly store the power cord in a protected and safe position.
Summary of Contents for AirPower
