8.
STORAGE & TRANSPORTATION
8.1.
Storage.
DO NOT touch the exhaust or the engine during use or for at least two hours after use. To prevent fire
hazard DO NOT move the generator into the storage area until it has fully cooled.
8.1.1. To keep generator in good condition
, i
t will be necessary to store the generator in the correct
way, the following steps are to protect the generator from rust and corrosion which would damage its
performance and appearance. When correctly stored the generator will be easier to start.
8.2.
Cleaning
8.2.1. If the generator has been stopped and is going to be cleaned before storage. You MUST allow
the machine to cool for at least 2 hours. Clean all surfaces of the machine, any damaged parts should
be treated to prevent rust from occurring.
8.3.
Fuel.
8.3.1. Over time diesel fuel deteriorates so it should be removed before storing the machine. Failure
to do so will result in the diesel fuel clogging up the fuel system which would be costly to rectify and
would not be covered under warranty.
8.4.
Storage area.
8.4.1. The storage area;
8.4.1.1. Should be dry, free of damp and have adequate ventilation.
8.4.1.2. Should be free of all sources of heat such as boilers, heaters etc.
8.4.1.3. Should be free of all sources of ignition such as naked flames, flammable materials etc.
8.4.1.4. The machine should be stored on a flat level surface and the wheels locked.
8.4.1.5. To prevent accidents or injury children and vulnerable persons should not be allowed access
to the storage area.
8.5.
Transport.
8.5.1. Before transporting the machine it should be allowed to cool for at least 2 hours.
8.5.2. All fuel should be removed prior to transportation.
8.5.3. The machine wheels must be locked and should be transported on a flat level surface to
prevent oil leaks. It should also be strapped securely to prevent damage during transport.
Page 17
First issue - 22nd November 2016
Summary of Contents for DHY12500SE
