4
3
Using The Remote Control
Description of Remote Start Fob
Button Functions
Note:
Make sure to press button only after LED lighting ends to activate each feature properly.
k
c
o
L
e
m
it
1
s
s
e
r
P
r
o
o
d
s’
r
e
vi
r
d
k
c
o
l
n
U
s
e
m
it
2
s
s
e
r
P
Press 2 times x 2
Unlock all doors
p
o
t
s
/t
r
a
t
s
e
t
o
m
e
R
s
d
n
o
c
e
s
2
d
l
o
H
Lock/Unlock
Note:
Press the button 1 time on the
transmitter to lock the vehicle.
Press the button 2 times to unlock the
driver’s door, and 2 additional times to
unlock all doors.
START/STOP:
Note :
Remote Engine Start -
Press the button 1 time and then,
within 3 seconds, press and hold
the button for 2 seconds.
Remote Engine Stop -
Press
and hold the button for 2 seconds.
Lock, Unlock and Remote
Starting icon is displayed with
one LED color.
Button Image
Button
LED/icon Feature
4
Driving Off
With the vehicle running remotely, press the button 2 times to unlock the driver’s door, enter the vehicle and perform the
following to drive off:
1) Insert the vehicle’s key to the IGNITION, turn to the ON position and press the brake pedal.
The vehicle is now ready to drive.
Note:
The Factory Key Fob will NOT function during Remote Start operation.
The engine will shut off if either of the following occurs;
1) The drive off procedure is not initiated within 30 seconds of opening any door, within 50 seconds of opening tailgate / trunk.
2) The brake is pressed without the vehicle key in the ignition in the ON position.
If the vehicle turnns off, simply start the vehicle using the normal starting procedure as detailed in the vehicle’s owner’s manual.
Remote Starting your Vehicle
Remote Starting
Using Remote Start Fob
1. Press button 1 time, the lock icon will display. Within 3 seconds, press and hold the button for 2 seconds,
the key icon will flash and the vehicle will start.
2. Remote Stop - Press and hold button for 2 seconds. The key icon will flash and the engine will turn off.
Note:
Make sure to press a button only after LED lighting ends to activate each feature properly.
Vehicle Presets
Heater
When leaving the vehicle, it is recommended to preset the climate controls in preparation for the next remote start. The climate
controls for the fan should not be left on HIGH. It is recommended to leave the setting on LOW or MEDIUM instead.
Windshield Wipers, Headlights
Certain vehicles require the windshield wipers and headlights circuits to become energized while running under remote start. When
leaving the vehicle you must ensure that the windshield wipers and headlights switches are OFF. Leaving the headlights switch ON
on certain types of vehicles could cause them to remain ON even after remote starter shutdown, resulting in a dead battery.
Leave Windshield Wipers off to avoid damaging the wipers/motor with remote start.
