Hyundai GR 009, Instruction Manual

ENG

31

/ 43

30

–  In terms of fire safety the grill conforms to the norm 

EN 60 335-2-6

. According to this norm this is 

an appliance that may be operated on a table or a similar surface under the condition that in the 

direction of the main heat radiation, i.e. above the hotplate, a safe distance of 

500 mm 

must be 

maintained from flammable materials and at least 

100 mm

 in the other directions.

– Regularly check the condition of the appliance’s power cord.

–  Use the appliance only for the purpose it is intended for, pursuant to these instructions for use. 

Never use the appliance for any other purpose.

–  The manufacturer takes no responsibility for damages caused by the incorrect use of this 

appliance and accessories (e.g. 

ruining of foods, injury, burns, scalding, fire

) and takes 

no responsibility arising from the warranty on the appliance in the case that the above safety 

notices were not followed.

DESCRIPTION OF THE APPLIANCE (pic. 1)

A – gril

A1 – thermostat knob

A2 – operating light indicator

A3 – heating elements

A4 –

grill rack (3 positions)

A5 –

aluminum tray

A6 –

handles

A7 – grill base

A8 – feets

A9 –

base holder

A10 –

bottom tray

A11 – upper column cover

A12 – column

A13 – lower column cover

A14 – wind rack

A15 – power cord

* Do not put food on bottom tray 

A10

 without packaging.

PREPARATION AND USE

Assembling and disassembling the grill 

(see scheme in pic. 1)

First attach the covers 

A11

 and 

A13

 to the posts 

A12

. Using screws, attach the posts to the base 

holder 

A9

 and the lower tray. You will get a stable bearing part of the grill. Then screw on the 

feet 

A8

 to the base 

A7

. You may then put thus assembled base on the above-mentioned bearing 

part. Put the aluminium tray 

A5 

onto the protrusions in the base 

A7

 in a way that the MIN and 

MAX marks are opposite the regulation knob. Now you can attach the whole part with the heating 

body and regulation knob into the prepared cut out parts of the base 

A7

 (see pic. 1). The guiding 

wire of the grilling grate must fit onto the prepared hollows of the aluminium tray (see pic. 1). Now 

put the wind shield 

A14

 in the base 

A7

 and then you may put the grilling grate on it.

Place the appliance on a hard and level surface. Place the aluminium reflector into the base and 

dip water carefully in before power on. 

Water must not come into contact with other parts of 

the grill (eg, A1, A2, A3, A15)

 ! The water shall not be lower than the minimum level marked on 

the 

A5

 tray. If water evaporates fast during baking, please add water into for avoiding over heat. 

Do not directly spray water onto the thermostat, for it may possibly damage the appliance.

Cautions!

–   The barbecue grill shall be covered with aluminium reflector or similar materials, otherwise 

it may cause the danger of overheat.

–   NEVER use the unit without water in the base tray. The water level must be between the 

MIN & MAX marks. When filling in water, turn the grill off frist and unplug the supply cord!