5
Instruction manual
Cassette playback
• Slide FUNCTION switch to TAPE (OFF)
position.
• Press
button to open the cassette
compartment.
• Insert a cassette and push the cassette
door to close the cassette compartment. The
full tape reel should be on the right side.
• Press button to start playback.
• Press button to pause playback. If you
press it again the playback will continue.
• Press
button to stop playback, press
the button again to open the cassette door so
you can take out the tape.
• When the tape plays to the end, playback
will stop automatically.
• Fast forward and rewind: You can run
forward and rewind the tape. Stop playback.
Use
button for fast forward and
button
for fast backward playback. When you have
reached the desired tape point, press
button to stop the process.
Never use fast forward or rewind
operations during playback. This may cause
damage to the tape.
Recording
Recording from radio
• Set FUNCTION switch to RADIO position.
• Select a band using AM/FM button.
• Tune to the desired station by turning
TUNING control regulator.
• Insert a blank cassette into cassette
compartment.
• Press button. The recording will start.
• For brief interruption press button. To
resume recording press the button again.
• To stop recording press
button.
Recording from CD
• Set FUNCTION switch to CD/USB
position.
• Insert your cassette tape in the cassette
compartment.
• Start the desired track playback.
• Press button. The recording will start.
• For brief interruption press button. To
resume recording press the button again.
• Press
button when finished. Then
stop CD playback by pressing button of the
CD player.
• You may want to monitor during
recording. You can adjust the sound with
VOLUME regulator. These adjustments do not
affect the content of recording.
• This deck is not suitable for recording
on CHROME (IEC II) or METAL (IEV IV) type
cassettes. For recording use NORMAL type
cassette (IEC I) on which the tabs have not
been broken.
• At the very beginning and end of the tape,
no recording will take place during 7 seconds,
when the leader tape passes the recorder
heads.
• When in process of recording or playback
the end of the tape is reached, the tape
stops automatically and the relevant button is
released.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• The heads and capstan are in constant
Summary of Contents for H-1425
Page 14: ......
