Hyundai H-CCR8086, Instruction Manual

4

Installation/Connection

Installation

General notes

•   Choose the mounting location where the 

unit will not interfere with the normal driving 
function of the driver.

•   Before finally installing the unit, connect 

the wiring and make sure that the unit works 
properly.

•   Consult with your nearest dealer if 

installation requires the drilling of holes or other 
modifications of the vehicle.

•   Install the unit where it does not get in the 

driver’s way and cannot injure the passenger if 
there is a sudden stop, like an emergency stop.

•   Avoid installing the unit where it would 

be subject to high temperature, such as from 
direct sunlight, or from hot air, from the heater, 
or where it would be subject to dust, dirt or 
excessive vibration.

DIN front-mount (Method A)

1.  Install the sleeve into the dashboard; 

ensure it is installed with the correct side and 
there are no obstacles (wires, dashboard 
elements, etc) for the unit installation.

2.  After installing the sleeve into the 

dashboard, bend tabs fitting to the size of the 
dashboard to fix the sleeve in place.

3.  Make the necessary wire connections. 

Ensure the connections are correct.

4.  Install the unit into the sleeve until the side 

locks are fixed.

2

1

182

53

1. Dashboard
2. Sleeve tab to bend

Trim frame installation

To install the trim frame, press it to the unit 

body and push it to fix it in place. This should be 
done before installing the front panel; otherwise 
you are not able to install the trim frame.

DIN rear-mount (Method B)

For this method, use the screw holes in the 

lateral sides of the unit. Fix the unit with the 
help of the factory radio mounting brackets.

1. Select a position in which the screw holes 

of the brackets (3) are aligned with the screw 
holes in the unit body, and screw in two screws 
(2) in each side.

2. Screw.
3. Factory radio mounting brackets.
4. Vehicle dashboard.
5. Lock (remove this part).

2

2

5

5

4

3

  The outer trim frame and mounting 

sleeve are not used for method of installation.

Dismantling the unit

a – Trim frame
b – Frame uninstall direction
c – Release key insertion