Hyundai H-CCR8091, Instruction Manual

Installation/Connection

4

technician check the system.

•   Always keep the volume low 

enough so that you can hear sounds 
from outside the vehicle.

•   Should this product fail to 

operate properly, contact your dealer 
or nearest service center.

Installation

General notes

•   Choose the mounting location 

where the unit will not interfere with the 
normal driving function of the driver.

•   Before finally installing the unit, 

connect the wiring and make sure that 
the unit works properly.

•   Consult with your nearest dealer if 

installation requires the drilling of holes 
or other modifications of the vehicle.

•   Install the unit where it does not 

get in the driver’s way and cannot 
injure the passenger if there is a 
sudden stop, like an emergency stop.

•   Avoid installing the unit where it 

would be subject to high temperature, 
such as from direct sunlight, or from 
hot air, from the heater, or where 
it would be subject to dust, dirt or 
excessive vibration.

DIN front-mount (Method A)

1. Install the sleeve into the 

dashboard; ensure it is installed with 
the correct side and there are no 
obstacles (wires, dashboard elements, 
etc) for the unit installation.

2. After installing the sleeve into the 

dashboard, bend tabs fitting to the 
size of the dashboard to fix the sleeve 
in place.

3.  Make the necessary wire 

connections. Ensure the connections 
are correct.

4.  Install the unit into the sleeve until 

the side locks are fixed.

2

1

182

53

1. Dashboard
2. Sleeve tab to bend

Trim frame installation

To install the trim frame, press it 

to the unit body and push it to fix it 
in place. This should be done before 
installing the front panel; otherwise you 
are not able to install the trim frame.

DIN rear-mount (Method B)

For this method, use the screw 

holes in the lateral sides of the unit. 
Fix the unit with the help of the factory 
radio mounting brackets.

1. Select a position in which the 

screw holes of the brackets (3) are 
aligned with the screw holes in the unit 
body, and screw in two screws (2) in 
each side.

2. Screw.
3. Factory radio mounting brackets.
4. Vehicle dashboard.
5. Lock (remove this part).