9.
Gas forced heater
5. OPERATION
Start
1. Install the switch in position « I » Fig. 3 and make sure that the fan is working properly.
2. Click gas valve, while pressing the button repeatedly piezoelectric element until then, until the
flames. Fig. 4.
3. When the system detects flame hold button valve within approximately 10 seconds. Fig.5. If after
that, the heater will switch off, wait one minute and repeat the operation, hold down the button of
the valve a little longer.
Shutdown
To turn off of the appliance you need to close the crane of gas cylinder. Let the fan runs until the
flame shall not be quenched. After that, install the switch fan position «Off».
Ventilation mode
Appliance can be used as a fan. In this case, disconnect the gas hose and insert the plug into the
outlet. To install the switch in position «On».
ATTENTION!
If the ignition has not happened immediately before to repeat the
operation, make sure that the fan is not blocked, and that the input
and output of the air nothing prevents.Do not use the heater during
sleep.
Always use only certified, recommended by the manufacturer,
and properly rated hoses/pressure reducers for connection of the
appliance.
Always use only the gas type indicated by the manufacturer.
EN
Fig. 3
Fig. 4
Fig. 5
