12
13
Operation
Operation
• DIGITAL OUTPUT
SPDIF/OFF: no digital signal out (coaxial
output off), only analog audio output.
SPDIF/RAW: digital signal output in the
original format recorded in the disc.
SPDIF/PCM: digital signal output in the
decoded PCM form.
• LPCM OUTPUT
Select PCM frequency at 48 kHz or 96 kHz
Some amplifiers don’t support 96 kHz
sampling and cause coaxial output abnormal.
HDCD
You can select the digital filter Off, 1x, 2x.
The initial factory setup is Off.
Dolby digital setup
General
Dolby digital setup page
Dual mono
Dynamic
Audio
Dolby
Video
Preference
• DUAL MONO
Stereo: stereo output signal,
L-Mono: left output signal,
R-Mono: right output signal,
Mix-Mono: left/right output average signal.
• DYNAMIC
If watching large dynamic scope movie
program at night, to select this mode you can
reduce the volume to a very low level, at the
same time, to keep the fine details sounds. In
this case, this doesn’t disturb the family and
keep the quality sounds.
Video setup
General
Video setup page
Video output
Color setting
Audio
Dolby
Video
Preference
• VIDEO OUTPUT
OFF: set video output to the composite.
RGB: set video output in Red/Green/Blue
format when connecting to SCART terminals.
If the video setting differs with the
physical connection, the TV set may be without
picture. In case of no picture, you can reset the
setting, then keep pressing V-MODE button
until the picture is OK again.
• COLOR SETTING
You can set the Sharpness, Brightness,
Contrast, Gamma, Hue, Saturation, according
to your preference.
Preference setup
General
Preference page
TV type
PBC
Audio
Subtitle
Disc menu
Parental
Password
Default
Audio
Dolby
Video
Preference
• TV TYPE
This unit is suitable for all kinds of TV
systems. You can select one of the PAL, NTSC
or Auto.
AUTO: the TV system is auto switched
according to the disc system.
