18
4). Pull the thrower softly until you feel a resistance,
then pull with a sharp blow.
Be careful to accompany the handle to avoid a
sudden return of it on the engine of the machine.
Pic.D
5). After the machine has started, return the choke
to the ON position
Pic.E
6). Allow the machine to warm up for 2-3 minutes.
2. Warm engine start
1). To restart the machine when the engine is warm, put the choke in the ON
position.
2). Pull the starter gently until you feel a resistance, then pull with a sharp jerk.
3). Let the engine run until it reaches a steady state.
3. Stopping
WARNING! The cutting device may continue to run for a
few seconds after stopping the machine.
1). Release the throttle trigger and let the engine idle.
2). Turn the ON/OFF switch to the off position (O).
If you experience unusual and excessive vibrations, stop the machine immediately.
Perform the checks to determine the cause.
Summary of Contents for HDBT32
Page 27: ...25...
