3-173
INSTALLATION OF INPUT SHAFT, OUT-
INSTALLATION OF INPUT SHAFT, OUT-
PUT SHAFT, PUMP SHAFT (POWER-
PUT SHAFT, PUMP SHAFT (POWER-
TAKE OFF SHAFT) AND CLUTCHES
TAKE OFF SHAFT) AND CLUTCHES
If the suction tube (1) in the housing front
part is to be replaced, it is imperative to
use the special tool (rolling tool) for
a s s e m bl y. T h e n f i x t h e t u b e w i t h
cylindrical screw (2). (Oil cylindrical screw)
It is always necessar y to use new
cylindrical screws.
·
Tightening torque (M8/8.8
×
12) :
2.34 kgf
·
m (17.0 lbf
·
ft)
Rolling tool 5870 600 003
Lubricant 5870 451 006
7609ATM306
9)
9)
(1)
※
1
2
The spare parts service supplies the lubri-
cating oil tube (1) only as a complete
package with the housing front part.
Single parts delivery upon request only.
Assembly is only possible with the spe-
cial tool.
Rolling tool
5870 600 005
Lubricant
5870 451 006
7609ATM307
Mount O-rings 22
×
3 into the annular
groove of the oil tubes (1 and 2) and oil
them.
Then insert tubes into the housing front
part, oil cylindrical screws (3 and 4) and
fix them.
It is always necessary to use new cylindri-
cal screws.
·
Tightening torque (M8/8.8
×
12) :
2.34 kgf
·
m (17.0 lbf
·
ft)
·
Tightening torque (M8/8.8
×
50) :
2.34 kgf
·
m (17.0 lbf
·
ft)
7609ATM308
※
※
※
(2)
※
1
1
4
3
2
3
4
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
