3-234
Setting of rolling torque of input pinion
Setting of rolling torque of input pinion
bearing
bearing 0.15~0.41
0.15~0.41 kgf
kgf
·
m
m (1.11~2.95
(1.11~2.95 lbf
lbf
·
ftft)
(without shaft seal)
(without shaft seal)
Insert spacer (e.g. s = 8.18 mm).
According to our exper ience the
necessary rolling torque is obtained
when reusing the spacer which has been
removed during disassembly (e.g. s =
8.18 mm).
A later check of the rolling torque,
however, is absolutely necessary.
Heat the tapered roller bearing and insert
it into the input pinion until contact is
obtained.
⑦
7609AAX117
7609AAX118
⑧
※
Insert the preassembled input pinion into
the axle drive housing and insert the
heated tapered roller bearing until
contact is obtained.
Press the protection plate onto the input
flange (see arrow) until contact is
obtained.
Do not fit the shaft seal until the contact
pattern has been checked.
7609AAX119
7609AAX120
⑨
⑩
※
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
