3-235
Insert input flange and fix it by means of
disk and slotted nut.
·
Tightening torque :
122 kgf
·
m (885 lbf
·
ft)
Slotted nut wrench
5870 401 139
Clamping device
5870 240 002
Preliminarily mount slotted nut without
loctite.
While tightening rotate the input pinion
While tightening rotate the input pinion
several times in both directions.
several times in both directions.
7609AAX122
7609AAX123
7609AAX121
7609AAX124
⑪
※
Check rolling torque (0.15~0.41 kgf
·
m)
without shaft seal).
When installing new bearings try to
achieve the upper value of the rolling
torque.
I n c a s e o f d e v i a t i o n s f r o m t h e
I n c a s e o f d e v i a t i o n s f r o m t h e
necessary rolling torque correct with a
necessary rolling torque correct with a
corresponding spacer (AX118, page
corresponding spacer (AX118, page
3-234) as specified below.
3-234) as specified below.
Insufficient rolling torque
Insufficient rolling torque
install thinner spacer ring
install thinner spacer ring
Excessive rolling torque
Excessive rolling torque
install thicker spacer ring
install thicker spacer ring
Grease O-rings (2EA, see arrows) and
insert them into the annular grooves of
the piston.
Operation figure AX123 and AX124 is
only necessar y for hydraulic lock
differential (option).
Insert piston (see arrow) into the bearing
housing until contact is obtained.
⑫
※
⑬
※
⑭
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
