3-248
7609AAX166
1 Planetary
carrier
2 Output
shaft
X Gap
width
Select the cover (optional) on the basis
of the following table.
Cover (
ZGAQ-04370
) has an offset of
0.07 mm on one side and an offset of
0.13 mm on the other side.
Offset 0.13 mm is visually marked with an
annular groove (see arrow).
※
※
22
7609AAX167
Insert the cover with the offset e.g.
0.07 mm showing to the planetary carrier
and tighten with new
new locking screws.
When using the cover with offset
0.07 mm, the groove (figure AX167) must
be visible when the cover is installed.
Tighten locking screws successively with
a tightening torque of 20.4 kgf
·
m (148
lbf
·
ft).
Then retighten the locking screws
successively with a tightening torque of
51 kgf
·
m (369 lbf
·
ft).
※
※
23
7609AAX168
Determined gap
width (Delta)
Offset to be used
on the cover
P/No.
0.30~0.24 mm
0.13
±
0.01 mm
ZGAQ-04137
0.239~0.18 mm
0.07
±
0.01 mm
ZGAQ-04370
0.179~0.10 mm
0.0 mm
ZGAQ-03909
Install O-ring (see arrow 1) to the cover.
Then wet contact face (arrow 2).
Use new cover and O-ring.
※
24
7609AAX169
1
2
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
