5-42
Place the distributor plate so that the
channel holes match the holes in the
housing.
(22)
Guide the cardan shaft down into the bore
so that the slot is parallel with the
connection flange.
(23)
(780-3A) 5-82(3)
(780-3A) 5-82(4)
Place the cardan shaft as shown - so that
it is held in position by the mounting fork.
(24)
(780-3A) 5-83(1)
Grease the two O-rings with mineral oil
approx. viscosity 500 cSt at 20˚C and
place them in the two grooves in the gear
rim. Fit the gearwheel and rim on the
cardan shaft.
(25)
(780-3A) 5-83(2)
Summary of Contents for HL955
Page 557: ...7 6 MEMORANDUM MEMORANDUM ...
