- Hold the drill by grasping the holding handle and main handle
- Gradually increase the speed by pressing and holding the safety switch and then pulling the acceleration
trigger. Exert some downward force.
- When the drill rod has penetrated 10cm into the ground, grasp the frame strongly and increase the effort
downwards.
- To drill a deep hole, lower the rod gradually.
- When you have dug the required size, decrease the drilling speed.
- Remove the rod, then stop the machine.
- You can start drilling another hole.
- To stop the machine, release the trigger and turn the switch to OFF. Let the machine stop completely
before placing it on the ground.
4.4 PRECAUTIONS DURING THE OPERATION
- Spectators (especially children and animals) should remain at least 5 meters away from the workspace.
Stop anyone from entering the workspace during the operation.
- When a person comes close, stop the machine to avoid possible injury.
- Pay attention to your work and the environment where you work. Stop the operation immediately when
something unexpected happens.
- Avoid working on slopes. If you absolutely have to work on a slope, pay double attention to avoid
accidents and injuries.
- Stop the machine when you take a break, change the workplace and leave the machine
unattended.
- Never touch the drill rod while operating the machine. Any intervention on the machine should be
done with the machine switched off and cooled.
- During the operation, move all parts of the body away from the rod.
- Wait until the machine has stopped completely before placing it on the ground.
10
