4. USE
4.1 DRILL ROD ASSEMBLY
- Place the machine body on a flat and stable location.
- Remove the clip and pin on the drill rod.
- Install the rod and align the holes to be able to connect the two sets.
- Put the pin back in place by clipping.
- Release the clipping and remove the pin.
4.2 BEFORE USE
- Check the condition of the machine, that there is no damage or malfunction. In case of problems, do not
use the machine and inspect it.
- Check that the drill rod is properly assembled.
- Check the fuel volume. Always refuel before operating the machine. Never use the machine with little or
no fuel.
- Check the workspace; remove all obstacles, materials and objects that could pose danger and cause an
accident.
- Secure the workspace by placing markings to alert spectators of existing potential
risk.
4.3 USE
- Hold the drill vertically. Place the rod against the ground.
- Switch on the machine by turning the switch to ON position, Press the priming pump several times, move
the choke lever to off position, pull the launcher cable several times, move the choke lever to ON position.
- Pull the launcher cable to start the machine.
09
