8-106
Remove the O-rings (35, 39) and backup rings
(47 , 48) from the piston (12).
Do not reuse O-rings (35, 39) and backup rings
(47, 48) after removal.
Disassembling the hydraulic motor part
Lay the travel motor body on the side.
Drain out the oil from the travel motor.
Place an oil receptacle under the travel motor to
receive the oil flowing out as the motor is being
laid on the side.
Hold the cylinder block (4) with both hands, and
remove it from the shaft (2).
Remove the mating plates (16) and friction plates
(15) from the cylinder block (4).
Before removal, hold the cylinder block (4) with
both hands and turn it two to three times in a
clockwise and a counterclockwise direction
alternately to detach the shoe (6) from the swash
plate (3).
Be careful that if an attempt is made to remove
the cylinder block (4) without detaching the shoe
(6) from the swash plate (3), then the piston, shoe
and other parts that are connected to the cylinder
block may come the cylinder loose and fall into
the spindle (101).
Θ
ö
Η
Θ
ö
Ι
Κ
ö
ö
14098TM27
14098TM28
14098TM29
(13)
Summary of Contents for HX145 LCR
Page 11: ...SECTION 1 GENERAL SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10...
Page 204: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV...
Page 627: ...8 155 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29...
Page 657: ...8 185 8 185 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10...
