8-124
2. DISASSEMBLING AND ASSEMBLING
GENERAL INSTRUCTIONS
Generally, hydraulic equipment is precisely manufactured and clearances between each parts are
very narrow. Therefore, disassembling and assembling works should be performed on the clean
place where dusts hardly gather. Tools and kerosene to wash parts should also be clean and
handled with great care.
When motor is removed from the host machine, wash around the ports sufficiently and put the
plugs so that no dust and/or water may invade. Take off these plugs just before the piping works
when re-attach it to the host machine.
Before disassembling, review the sectional drawing and prepare the required parts, depending on
the purpose and the range of disassembling.
Seals, O-rings, etc., if once disassembled, are not reusable.
There are some parts that should be replaced as a subassembly.
Consult with the parts manual in advance.
The piston can be inserted to whichever cylinder block for the initial assembling.
However, their combination should not be changed if they are once used. To reuse them, put the
matching mark on both pistons and cylinder block before disassembling.
Take great care not to pinch your hand between parts while disassembling nor let fall parts
on your foot while lifting them.
1)
(1)
(2)
(3)
(4)
Summary of Contents for HX145 LCR
Page 11: ...SECTION 1 GENERAL SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10...
Page 204: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV...
Page 627: ...8 155 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29...
Page 657: ...8 185 8 185 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10...
