8-108
Caulk carrier holes as shown on the picture.
(4)
25098TM146
25098TM147
ASSEMBLING CARRIER 2 ASSY
Put No.2 carrier on a flat place.
Install No.2 needle bearing into No.2
planetary gear, put 2EA of No.2 thrust
washer on both sides of planetary gear, and
then, install it into carrier.
3)
(1)
(2)
After install solid pin into the holes, install
No.2 pin into No.1 carrier where the holes for
No.1 pin are to be in line with those of No.1
carrier, and then, install spring pins into the
holes.
Caulk carrier holes as shown on the picture.
(3)
(4)
25098TM148
ASSEMBLING FLOATING SEAL
Assemble floating seal into motor by use of
pressing jig.
Grease the contact parts for floating seal
which is assembled into motor.
Be sure to maintain it vertical with the ground
when assembling bearing and floating seal.
4)
(1)
侍
25098TM149
