5.2.2
Change the oil;
5.2.2.1
Ensure machine Is on level ground.
5.2.2.2
Turn OFF using power switch (3) machine then isolate from power
source.
5.2.2.3
Have a container to collect old oil, do not dispose of down any drain/s.
5.2.2.4
Remove filler knob (2) and place somewhere safe.
5.2.2.5
Open drain plug using a spanner and rotate anti-clockwise. Put drain
plug somewhere safe (8).
5.2.2.6
Release oil.
5.2.2.7
Clean area with clean rags and reinsert oil drain plug using a spanner
and rotating clockwise.
5.2.2.8
Fill with 15W 40 using a funnel, make sure any spilt oil ls cleaned
up thoroughly.
5.2.2.9
not overfill
5.2.2.10
On completion replace filler knob by turning anticlockwise.
6.
WARNINGS
6.1
DO NOT release any joints whilst the machine is under pressure.
6.2
Before attempting any such work make sure the machines air pressure has been
released.
6.3
To release the pressure inside the machine;
6.3.1
Turn the machine OFF.
6.3.2
Unplug unit from the supply.
6.3.3
Pull yellow release knob (9) until all air has been released.
6.4
Ambient working temperature Is 0°C to +30°C.
6.5
DO NOT point water or flammable liquids towards the machine.
6.6
DO NOT place flammable liquids and or materials near machine.
6.7
DO NOT direct air nozzles towards any persons or animals.
6.8
DO NOT allow children or un-authorised and untrained persons to use this machine.
6.9
If the machine is used for painting;
6.9.1
DO NOT operate in enclosed spaces or in the proximity of naked flames.
6.9.2
Make sure the area in which you are working in has sufficient change of air.
6.10
Use correct Personal Protective Equipment.
6.11
Always turn machine OFF after use.
7.
MACHINE DETAILS
7.1
Maximum pressures;
7.1.1
Working pressure 8.5 bar.
7.1.2
Utilisation pressure 8.0 bar.
7.2
For the European market the compressor tanks are built in accordance with the
following EC Directives;
7.2.1
87/404 Simple Pressure Vessel Directive
7.2.2
2006/42 Machinery Directive.
7.3
Sound levels measured at 1 metre ±3dB (A) are as follows;
HP
RPM
dB (A)
1.5
2800
97
2.0
2800
97
2.5
2800
97
N.B. The sound level value may increase by 1dB (A) to 10dB (A) dependent upon area where work is carried out.
Page 5
Rev 5
