10
NOTE
ALWAYS check the engine oil and pump oil before starting.
4.0
Check the air outlet valve on the tank end-plate is closed.
4.1
Ensure that the engine oil and pump oil levels are correct.
4.2
Turn the ignition switch to the ON position and move the choke lever half way.
4.3
Gently pull the recoil start handle until you feel resistance and then pull swiftly until
the engine starts.
DO NOT allow the starter handle to snap back, gently return it to the start position.
4.4
Once running, move the choke to the OFF position.
4.5
When the engine is running smoothly, the compressor will operate automatically,
building up the pressure in the tank, which is shown on the pressure gauge to the
maximum setting (factory set).
4.6
When the maximum tank pressure has been reached, the relief valve will automatically
vent the pump output, when the tank pressure falls below the minimum threshold
(approx. 2bar/29psi less than the maximum pressure), the relief valve will automatically
close and the tank pressure will increase back to its maximum.
4. STARTING PROCEDURE
Summary of Contents for HY140200PES
Page 1: ...1...
