Hyundai HY155HPW-1, Instruction Manual

environments or areas.

•

WARNING: During operation, do not place

the machine in areas of poor aeration and

much less cover it.

•

WARNING: Avoid using the machine in the

rain and do not direct the jet at it.

•

WARNING: Do not use the unit on flammable 

surfaces.

•

 WARNING:

- NEVER EVER TOUCH THE MACHINE WITH WET

HANDS OR BARE FEET.

- NEVER PULL THE POWER SUPPLY CABLE OR

MACHINE IN ORDER TO DISCONNECT THE PLUG 

FROM THE SOCKET.

- IF DURING FUNCTIONING THE POWER SUPPLY

RUNS OUT, FOR SAFETY REASONS, TURN THE

MACHINE OFF.

> SAFETY DEVICE

S

•

 WARNING: the gun is fitted with a safety

catch. Whenever use of the machine is

interrupted it is important to operate the

safety catch to prevent accidental activation

of the jet.

-  Safety features: gun equipped with safety

locking device, appliance equipped with

(Class I) overload cutout, pump equipped

with by-pass valve or shutdown device.

-  The safety button on the gun is not there

to lock the lever during operation, but to

prevent its accidental operation.

•

 WARNING:  The appliance is equipped

with a motor protection device: in case of

device intervention, wait some minutes or,

in alternative, disconnect and re-connect

the product to the electric system. In case

this problem repeats again or if the product

does not start again, take the product to the

nearest After Sales Service Point

> STABILITY

•

 WARNING: 

The machine must be always kept

on horizontal bases, in a safe and stable way.

> WATER SUPPLY

 Water supply collection

Water supply from the water main

· Connect a supply hose (not included) to

the water inlet of the unit and to the water

supply.

·  Open the water supply.

 WARNING: (symbol) machine not suitable 

for connection to the potable water mains.

The cleaner can only be connected to the wa-

ter mains if the water mains is separated by a 

backflow preventer. Make sure that the hose 

is at least Ø 13mm-1/2 inch and that it is rein-

forced.

• 

WARNING: Water that has flown through

backflow preventers is considered to be

nonpotable.

IMPORTANT: Only clean or filtered water

should be used for intake. The delivery of

the water intake tap should be equal to the

double of the maximum pump range. 

-  Minimum delivery rate: 30 l/ min.

-  Maximum intake water temperature: 40°C

-  Max inlet water pressure: 1Mpa

Place the cleaner as close to the water supply

system as possible.

Water supply from an open container

· Unscrew the coupling part for the water

inlet.

· Screw the suction hose with filter (not

included) onto the water connection of the

unit.

· Hang the filter in the container.

·  Vent the unit before operation.

· Unscrew the high-pressure line at the high-

pressure outlet of the unit.

· Switch on the unit and let it run until water

free of bubbles emerges at the high-pressure 

outlet.

· Switch off the unit and screw on the high-

pressure hose again. 

Failure to comply with the above conditions 

causes serious mechanical damage to the 

pump and the loss of warranty cover.

> ELECTRICITY SUPPLY

-  The appliance’s electrical connection must

comply with the IEC 60364-1 standard.

A QUALIFIED ELECTRICIAN must carry out

the following:

-  If the power supply cable is not available and 

if the device is not to be connected in a fixed 

EN

1

3