6.
INSTALLATION & COMISSIONING.
Before commissioning, all parts should be completely installed.
6.1
Installation of the wheels and foot.
6.1.1
Select parts as shown in image below (1).
6.1.2
Assemble as shown in (1)(2) by taking bolt (a) and pushing it through the centre hole
of wheel (b), then put washer over protruding bolt (a). Then pass bolt through wheel frame (g),
next put washers (d) and (e) over bolt, finally secure the bolt using nut (f). DO NOT overtighten the
bolt, the wheel must be left free to spin on the bolt (axle).
6.1.3
Using parts provided (shown in image (3)) below.
6.1.4. Assemble as shown in (3) take bolt (a) and pushing it through the centre hole of foot
(b), push protruding bolt through frame (d) then finally secure the bolt using nut (c). Make sure
that the nut and bolt are tightened to prevent the foot coming loose. DO NOT Overtighten.
Page 10
Rev 2
Summary of Contents for HY2524
Page 1: ......
