10
WARNING
Seek assistance when removing the compressor from its packaging.
4.0
Remove the compressor from its packaging and inspect for any damaged parts.
If anything is found to be missing or damaged, contact your supplier.
4.1
Take care to transport the compressor correctly, do not overturn it or lift it with hooks
or ropes.
4.2
Position the compressor on a flat, level surface or with a maximum permissible
inclination of 10°.
4.3
Site in a well-ventilated area.
4.4
If the surface is inclined and smooth, check if the compressor moves whilst in operation.
4.5
If the surface is in a raised position, make sure the compressor cannot fall, securing
it in a suitable way.
4.6
Connect your air supply hose to a ¼” male universal or industrial quick connector
coupler.
Connect the male quick connect coupler to the female quick connect coupler located
on the air compressor.
4.7
Make sure the drainage valve is off and that the pressure switch is in the OFF position.
4.8
Ensure that the power supply that you are going to use is operating normally.
4.9
Insert the power supply cord into the power supply socket.
NOTE
Before using the air compressor for the first time, complete a test run as follows:
4.10
Turn the power switch to the OFF Position.
4.11
Plug the power supply cord into a power supply socket.
4.12
Start the air compressor by turning the power switch to the ON position.
4.13
The pressure gauge reading will slowly rise as pressure increases inside the air tank.
4.14
When the gauge reading reaches working pressure, the pressure switch will
automatically torn the power off.
This indicates the compressor is working normally.
4.15
Turn the power switch to the OFF position, unplug the power supply cord and release
the air in the tank by pulling the safety valve.
4.16
If the compressor is not working properly, the pressure gauge will indicate that there
is a decrease in pressure in the air tank.
If there is an air leak from the compressor the pressure in the air tank decreases, the
pressure switch resets and the motor automatically turns back on.
4.
PREP
A
RATION
TEST RUN
