11
5.0
5.1
5.2
5.3
5.4
5.5
5.6
5.7
5.8
Check that the power switch is in the OFF position.
Attach the air hose to the ¼” quick disconnect coupler.
Close the drain valve and ensure the air filter is installed.
Close the drain valve.
Plug the compressor in to a working plug socket.
Turn the power switch to the ON position.
Allow the motor to run and fill the tank until the motor turns off.
To regulate the air flow: While the air compressor is running, turn ON your tool and
turn the regulator kno
b
to the right increasing the pressure.
Turn the pressure up until the desired pressure is reached.
(N.B. Pressure on
HY5508 is not adjustable).
Operate air tool normally.
6.0
Turn the power switch to the OFF position.
6.1
Unplug the compressor.
6.2
Reduce the pressure in the air tank through the air supply hose.
7.0
7.1
7.2
7.3
7.4
7.5
7.6
To determine the correct working pressure and air flow requirements for any piece
of equipment, check the corresponding manual.
Be aware that the air flow figure stated on tools and accessories refers to ‘free air
delivery’ and not the piston displacement of the compressor.
When adjusting the regulator, always adjust up to the required pressure.
After fitting the desired coupling to the outlet valve, connect an air hose and hook up
to an air system
At the end of each working day, drain any moisture from the main tank.
Place a container under the drain plug and then carefully unscrew it anti-clockwise.
DO NOT allow moisture to accumulate in the tank as this will corrode the inside of
the tank and affect the pressure rating of the tank.
5. STARTING PROCEDURE
6. STOPPING PROCEDURE
7. USING THE MACHINE
