25
8. USING THE MACHINE
CAUTION
Engine housing can become hot during trimmer operation.
DO NOT
rest or place your arm, hand or any body part against the engine housing
during trimmer operation.
Extended contact with the engine housing can result in burns or other injuries.
ALWAYS
position the unit on the operator’s right side.
The use of the machine on the operator’s left side will expose the user to hot
surfaces and can result in possible burn injuries.
To avoid burns from hot surfaces,
NEVER
operate the machine with the bottom
of the engine above waist level.
WARNING
You MUST STOP using the machine if any of the following occur.
The engine speed changes with no control.
When blades are damaged.
In case of misfire.
In case of high vibration.
In rain or stormy weather.
CAUTION
When you use this machine, always wear the provided harness.
Make sure that the machine is securely hooked onto the strap.
If you do not, you will not be able to control the machine safely which may result
in injury to yourself or others.
NEVER
use the harness with any type of defect, especially with a defective quick
release mechanism.
6.0
Always trim or cut with the engine running at high speed.
6.1
Do not run the machine slowly except for when warming up before use or cooling
down after use.
6.2
Swing the cutting head of the cutter horizontally from left to right.
6.3
Keep the cutting deck parallel with the ground.
DO NOT
tilt the cutting blade head
during operation.
6.4
Keep the cutting blade at the same level for even depth of cut.
6.5
The metal blade is to be used for brush only.
6.6
To prevent overheating
NEVER
over cut, instead cut off smaller lengths of brush.
6.7
If brush becomes tangled in the blade, you
MUST
stop the engine and remove the
spark plug HT lead cap
BEFORE
attempting to remove the blockage.
6.8
NEVER
raise the cutting blade above knee height during operation.
6.9
DO NOT
use the machine on a slope or uneven ground or if there is the chance
of slipping or losing stability.
Summary of Contents for HY4BC31
Page 1: ...PETROL BRUSHCUTTER HY4BC31 User Manual...
Page 38: ...38...
Page 39: ...39...
Page 40: ...Imported Distributed by GENPOWER LTD Licensed by Hyundai Corporation Korea...
