10
NOTE
ALWAYS check the engine oil and pump oil before starting.
Severe engine or pump damage may otherwise result.
4.0
Check that the air outlet valve on the tank end-plate is closed.
4.1
Ensure that the engine oil is topped up.
4.2
Turn the ignition switch to the ON position and move the choke lever to half way.
4.3
Pull the recoil start handle until you feel resistance and then pull swiftly until the
engine starts.
DO NOT allow the starter handle snap back, gently return it.
4.4
Once running, move the choke to the OFF position.
4.5
When the engine is running smoothly, the compressor will operate automatically,
building up the pressure in the tank, which is shown on the pressure gauge to the
maximum setting (factory set).
4.6
When the maximum tank pressure is reached, the relief valve will automatically
vent the pump output when the tank pressure falls below the minimum threshold
(approx. 2bar/29psi less than the maximum pressure), the relief valve will automatically
close and the tank pressure will increase back to its maximum.
4. STARTING PROCEDURE
Pressure Gauge
Ignition Switch
Pressure Relief
Valve
