8
2.13
DO NOT operate the compressor within the vicinity of flammable liquids, gases
or solids.
2.14
DO NOT touch the compressor cylinder, cylinder head or pipe from the head to the
tank as these may be hot and will remain so for some time after shutdown.
2.15
DO NOT operate the compressor without all safety guards in place.
2.16
DO NOT attempt to move the compressor by pulling the air hose.
2.17
DO NOT use the compressor for a task for which it was not designed.
2.18
DO NOT deface the certification plate attached to the compressor tank.
2.19
DO NOT operate the compressor without an air filter.
2.20
DO NOT use the compressor indoors, the exhaust fumes are poisonous.
2.21
DO NOT allow anyone to operate the compressor unless they have received full
instruction.
2.22
DO NOT check the ignition system by removing the spark plug or spark plug lead.
Use a specific tester or contact the service agent.
2.23
Make sure that the engine fuel is stored in an appropriate container. For long term
storage ensure that the fuel tank is drained and that the compressor is adequately
protected.
2.24
DO NOT smoke or have any naked flames nearby whilst refuelling.
2.25
DO NOT leave the compressor unattended.
2.26
DO NOT remove the fuel cap, or try to refuel whilst the engine is running.
Stop the engine and allow it to cool for two minutes before attempting to refuel.
2.27
DO NOT refuel in a closed or poorly ventilated environment as there is a danger
of explosion or fire. Refuel outdoors.
2.28
DO NOT operate the compressor if there is a fuel leak. Move the unit to a safe area
where there is no risk of ignition until the leak has been rectified and the machine is
dry.
2.29
DO NOT block the engine ventilation grills.
2.30
DO NOT cover the compressor or restrict airflow around the machine whilst it it
operating.
2.31
The air tank is a pressure vessel and the following safety measures apply;
DO NOT tamper with the safety valve and DO NOT modify or alter the tank in any
way.
DO NOT strap anything to the tank.
DO NOT subject the tank to impact, vibration or heat.
DO NOT allow contact with abrasive or corrosive materials.
YOU MUST drain condensation from the tank daily and inspect inside walls for
corrosion every 12 months.
2.32
ALWAYS wear the appropriate Personal Protective Equipment (PPE).
