4. OPERATING PROCEDURES
Always wear correct PPE when using
machine - Before starting make sure the
cutting attachment is not touching
anything.
4.1.
Starting.
4.1.1.
Set ignition switch (8) to the ON position. Push
priming bulb (5) several times so that fuel flows
through return the pipe.
4.1.2.
With the safety trigger (9) pressed, pull throttle trigger (7) and push throttle lock (10), then
slowly release the throttle trigger then the safety
trigger. This will lock the throttle in the starting
position.
4.1.3.
Set choke lever (3) to
position.
4.1.4.
Pull recoil s tarter briskly, taking care to keep the
handle in your grasp and not allowing it to snap back.
4.1.5.
When you hear the engine want to s tart, return
choke lever to
position. Then pull recoil starter
briskly again.
If the machine does not start, repeat
procedure from 2 to 5.
4.1.6.
After starting engine, pull throttle trigger to
release throttle lock. Then allow the engine about 2-
3 minutes to warm up before subjecting it to any
load.
4.2.
Cutting.
4.2.1.
When cutting, operate engine at over 6500 rpm.
Extended use at a low rpm will wear the clutch
prematurely.
4.2.2.
Cut grass from right to left.
4.2.3.
A dangerous reaction may occur causing the
entire unit and operator to be thrust violently. This
reaction is called BLADE THRUST. As a result, the
operator may lose control of the unit
which may cause serious or fatal injury. Blade
thrust is more likely to occur in areas where it is
difficult to see the material to be cut.
4.2.4.
Blade thrust may occur when the spinning blade
contacts a solid object in the critical area.
Page 11
Ver 4
Summary of Contents for HYBC3000
Page 1: ......
Page 17: ...9 SPARE PARTS HYBC3000 HYBC3000 Page 17 Ver 4...
