3. ASSEMBLY
3.1.
Handle assembly.
3.1.1.
Attach clamp (1) to shaft using the supplied
screws (2).
3.1.2.
Place handle bar (3) into clamp (1), then
place top clamp (4) into the cradle part of
clamp (1), then place top clamp (4) over handle
bar. Using the fixing bolt (5) tighten until
almost secured, move handle bar until desired
position is found then tighten fully.
3.2.
Installing or replacing the cutting blade.
3.2.1.
Make sure the HT lead is removed from the
spark plug.
3.2.2.
Make sure the brush cutter is switched
off and the engine is fully stopped.
3.2.3.
Insert a screwdriver or equivalent into the
back shield and the adaptor semicircle hole to
prevent the output shaft from turning.
3.2.4.
Loosen the nut with the socket wrench (T-
Wrench) by turning clockwise (view from top).
3.2.5.
Then remove spring washer, washer, cover cap, spacer and cutter blade from
the output shaft.
3.2.6.
Remove the old cutter blade, and install the new blade.
3.2.7.
Install spacer B, the cover cap, the washer and spring washer, then tight the nut.
3.2.8.
Remove the ‘prevent rotational wrench’ or equivalent from the back shield and
adaptor.
3.2.9.
Before use remove the transportation guard.
3.3.
Installing the Trimmer Head.
3.3.1.
Make sure the HT lead is removed from the
Page 8
